Millipore Sigma Vibrant Logo

Colector de vacío MultiScreenHTS

For vacuum filtration of 96 and 384 samples

Recursos relacionados

Descripción

Especificaciones

Información para pedidos

Ir
Colector de vacío MultiScreenHTS para usar con las placas de filtración MultiScreenHTS de 96 y 384 pocillos así como con las placas de filtración MultiScreen Solvinert y Solvinert Deep WellBorrar Clasificación y Filtrado Show Filter
Número de referenciaDescripciónComponentesTamaño de envase
MSVMHTS00Colector de vacío MultiScreenHTS
  • incluye base del colector, cuello estándar, juntas tóricas, insertos para las juntas, todos los tubos, manómetro y válvulas
1 Precios y disponibilidad

Volver al principio

Colector de vacío MultiScreen para usar con placas de filtración estándar
MultiScreen (no-HTS) Borrar Clasificación y Filtrado Show Filter
Número de referenciaDescripciónComponentesTamaño de envase
MAVM0960RColector de vacío MultiScreen de 96 pocillos
  • incluye base del colector, junta estándar con juntas tóricas, rejilla-soporte, todos los tubos, manómetro y válvulas
1 Precios y disponibilidad

Volver al principio

Bomba de vacío – AccesoriosBorrar Clasificación y Filtrado Show Filter
Número de referenciaDescripciónTamaño de envase
SLFG05010Unidad de filtración Millex-FG; 0,20 µm, PTFE hidrófobo, 50 mm 10 Precios y disponibilidad
WP6110060Bomba de servicio químico, 100 V/50–60 Hz 1 Precios y disponibilidad
WP6111560Bomba de servicio químico, 115 V/60 Hz 1 Precios y disponibilidad
WP6122050Bomba de servicio químico, 220 V/50 Hz 1 Precios y disponibilidad

Volver al principio

Placas de recogidaBorrar Clasificación y Filtrado Show Filter
Número de referenciaDescripciónEsterilidadTamaño de envase
MSCPNPS00Placa de recogida de 96 pocillos, transparente, no estéril No estéril 100 Precios y disponibilidad

Volver al principio

Documentation

Referencias bibliográficas

Visión general referenciasAplicación
Method for Simultaneous Measurement of Antibodies to 23 Pneumococcal Capsular Polysaccharides
Raymond Biagini, Sonela Schlottmann, Deborah Sammons, Jerome Smith, John Snawder, Cynthia Striley, Barbara MacKenzie, and David Weisssman
Clinical and Diagnostic Laboratory Immunology September 2003, p 744-750, Vol. 10, No. 5  2003

A non-radiolabelled ferriprotoporphyrin IX biomineralisation inhibition test for the high throughput screening of antimalarial compounds.
E. Deharo, R. N. Garcia, P. Oporto, A. Gimenez, M. Sauvain, V. Jullian and H. Ginsburg
Experimental Parasitology 100 (4): 252-256  2002

High-Throughput Microplate Format for Producing and Screening Riboprobes from Bacterial Cells
Matthews, P.D. and Wurtzel, E.T.
BioTechniques. 18: 6, 1000 – 1004  1994

Nucleic Acid Purification and Concentration
Use of Multiscreen plates for the preparation of bacterial DNA suitable for PCR
Reek FH, Smits MA, Kamp EM, Smith HE
Biotechniques. 1995 Aug;19(2):282-5  1994

PCR

Preguntas frecuentes

PreguntaRespuesta
What plates are compatible with the MultiScreen manifold?In general, all manufacturers' plates fit the vacuum manifold.
I’m not getting good vacuum while using the MultiScreen vacuum manifold, what can I do?Press down on the MultiScreen plate to form a good seal with the manifold. (This is normal for the low vacuum used). Make sure all wells of the filter plate are either “wet” or sealed with adhesive tape. Check all tubing connections to make sure they are tight. See the MultiScreen Vacuum manifold operators guide for more detailed troubleshooting information.
What plates can be used with the MultiScreen HTS manifold (Catalogue number MSVMHTS00)?All MultiScreen HTS platform filter plates, Solvinert and Solvinert Deep Well plates can be used with the HTS manifold.
Can the classic MultiScreen plates be run on the HTS manifold?Only in filter to waste mode. The HTS plates should be used with the HTS manifold for the most benefit.
Can the MultiScreen HTS manifold be used with Millipore's genomics application plates (plamid prep, pcr cleanup, sequence reaction clean up)?Filter to waste modes work, but not filtrate collection, so using the clearing plate with the plamid plate will not work. Millipore's genomics plates have not been validated on the HTS manifold. Please contact technical service for more information at 1-800-645-5476.
If using the MultiScreen HTS manifold, when do I have to use the droplet trap array?The droplet trap array should be used when filtering a 384 well plate to waste.
If the deep well collar sold with the MultiScreen HTS manifold or is it sold seperately?The deep well collar is sold as an accessory to the MultiScreen HTS manifold; it does not come with the manifold. The catalogue number is MSVMHTS0D.
When using the MultiScreen HTS manifold, can I filter to waste when using a shallow well plate?Yes. The classic grid should be in place for removeable underdrain HTS plates or the collar gasket frame should be in place for Solvinert plates.
When using the MultiScreen HTS vacuum manifold, can I filter to waste when using a deep well plate?Yes. The deep well plate should be placed on top of the manifold collar with the clear gasket support installed.
When using the MultiScreen HTS manifold, how can I test to see if the manifold is properly installed and/or that I have enough vacuum for my application?The easiest way to test the manifold and/or set vacuum pressures is to put the collar on the base with nothing inside and place a collection (plastic bottom) plate on the top. You can now adjust the vacuum to the desired level.
Show more

Productos y aplicaciones relacionados

Familias de productos

Unidades de filtración Millex

Las unidades de filtración Millex con membrana hidrófoba Fluoropore son idóneas para la esterilización.
Más información >>

Productos relacionados por: Application Facete

Protein Purification
Sample Preparation
Dialysis and Filtration

Productos relacionados por: Brand Facete

MultiScreen™

Categorías

Life Science Research > Cell Culture and Systems > Cell Culture Flasks, Plates, & Slides > Multiwell Plates